This was one of two entries for the Piecework Magazine’s Excellence in Needlework 2009. This year’s challenge was to make a brooch no larger than 3″, in any needle art category. I chose ribbon work here and silk ribbon embroidery for my other submission Elizabeth’s Garden.
The base of the brooch is 18 gauge florist wire wrapped in cotton batting, then a silk bias ribbon. The brooch was fashioned into a spiral (see the bottom picture), with two loops. Tiny spirals of 22 gauge florist wire wrapped in cotton batting then 4mm silk ribbon peek out here and there, and add more dimension to the design.
The brooch was then covered in hand made ribbon worked flowers and leaves. I used 1/4″, 3/8″, 1/2″ and 5/8″ (folded in half); in a variety of materials including silk bias, rayon hem tape, ombre and taffeta ribbons. A few beads are sprinkled here and there for extra detailing.
The back of the brooch is almost covered with as many flowers as the front. I used a rococo trim to cover the bulk of the stitching, and then added in flowers and leaves here and there.
From this picture you can make out the spiral design of the base. You can see the tiny tendrils quite well here too, and if you look closely the pesky white batting wanted to peep out whenever it had a chance to from the 4mm ribbon, I fixed that before sending it off on it’s journey!
Both of my entries were selected by the judges to be included in a display of the brooches at The National Needle Arts Association’s trade show in Columbus, Ohio, June 13-15, 2009. They will also be on display at the Embroiderer’s Guild of America’s (EGA) museum in Louisville, Kentucky, from July 1 through September 23, 2009. For information contact EGA www.egausa.org (502) 589-6956.